In our kids’ science class, we built two variations on “Cars that Move.” The Retractable Badge car is a little more of an engineering project that kids might learn more from. This one is easier to build, and a quick route to a satisfying toy. (Here are other ideas for cars you can build.)

Tutorial – How to Build a Clothespin Racer

Here are step-by-step instructions with pictures.

Materials:

• Clothespins
• Pull Back & Let Go Racer Cars (these cars look similar to what I used in 2016 but I haven’t ordered them to be sure.) Or you can find similar cars at dollar stores.
• rubber bands, plastic straws and tape

Prep:

Cut plastic straw into 3/4″ lengths – these are about the same width as the front axle of your car. Then make a lengthwise cut in each one – you’re making a “sleeve” to fit the axle into. Note: To see a larger version of any image, just click on the picture.

Assembly:

Step One: Disassemble the car – pull the top off, carefully take the two halves apart, then take the front axle out of its plastic frame.

 

Step Two: Slip the front axle and wheels into the plastic straw. Tape the straw to the clothespin, right on top of the metal clip that holds the spring in place.

Step Three: Insert the rear wheel mechanism into the back end of the clothespin.

Step Four: Slip a rubber band on lengthwise to hold the rear wheels in place. OR use electrical tape to tape the back end and the front end – tape it tight so the tape offers a little tension. (Electrical tape works better than masking tape, as it has just a little stretch / flexibility.)

 Step Five: Try it out! Set it down, pull it back, release – it should travel several feet. Note: if you’ve used a rubber band to attach them, the rear wheels often slip slightly out of place when you run the car, so just check and re-align with the rubber band before each run.

Variation: Instead of using the straw as a casing for the front axle, with a little more prep work, you can file a groove in the clothespin (right in front of where the groove for the spring is), then place the axle directly in the groove (without a straw) and cover that with a bit of paper or folded tape to create the channel, then tape that in place to hold the front wheels in.

Decorating your Racer: Kids can write their names on their clothespin, or can decorate them. You could use regular markers or Sharpies, but my favorite thing for decorating wood is these washable Chalk Markers. They’re actually designed to use on chalk boards or glass, and warn you not to use them on porous surfaces like wood (because they won’t wash off), but I like the results we get using them on wood.

Check out our full Cars Lesson Plan for more car-themed activities for preschool and kindergarten.